ELECTRIC DRYER INSTALLATION INSTRUCTIONS U.S.A. ONLYPara una versión de estas instrucciones en español, visite www.Whirlpool.comTABLE OF CONTENTSDRYE
105. Tighten strain relief screw.6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw.7. You have co
114. Tighten strain relief screw.5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw.6. You have co
12Flexible metal vent Flexible metal vents are acceptable only if accessible for cleaning. Flexible metal vent must be fully extended and supported
ABCA. Standard rear offset exhaust installationB. Left or right side exhaust installationC. Bottom exhaust installation13Alternate installations for c
142. Firmly grasp the body of the dryer (not the console panel). Gently lay the dryer on the cardboard. See illustration. 3. Examine the leveling leg
15LEVEL DRYERCheck the levelness of the dryer. Check levelness first side to side, then front to back.If the dryer is not level, prop up the dryer usi
Try the following: Check to see if a household fuse has blown or circuit breaker has tripped. Electric dryers use two household fuses or breakers. Rep
2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
3Optional EquipmentRefer to your Use and Care guide for information about the accessories available for your dryer.Location Requirements You will need
BCA4Side ViewSteam (Electric or Gas)Non-Steam(Electric or Gas)A* 1" (25 mm) 1" (25 mm)B 7 5/8" (194 mm) 7 5/8" (194 mm)C 3 3/8&quo
5Recommended installation spacing for cabinet installationNOTE: Some models are not recommended for cabinet installation. For cabinet installation, w
6 To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply,
72. Remove the hold-down screw and terminal block cover.A. Neutral ground wire B. External ground conductor screwC. Center terminal block screwD. Term
8 Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position.
93. Connect ground wire (green or bare) of power supply cord to external ground conductor screw. Tighten screw.A. External ground conductor screwB. Gr
Comments to this Manuals