Roper TOP-MOUNT REFRIGERATOR Specifications download pdf (Page 14)

MULLION EVAPORATOR DESIGN 12 cu. ft. Top-Mount

Accessing Freezer Compartment Components

The center rail covering the mullion between the freezer and refrigerator compartments and the

freezer floor must be removed to gain access to components in the freezer compartment.

1. Remove both doors and the center hinge. Also remove the screws on the other side of the

center rail.

2. Press in on the left side of the center rail while sliding it to the left. This will release the right end

of the center rail from the cabinet.

3. Slide the center rail to the right to release the left end from the cabinet.

4. Carefully slide the freezer floor out of the freezer compartment.

5. Lift the Styrofoam evaporator housing cover and aluminum heater shield from the bottom of the

freezer compartment.

The evaporator is surrounded by Styrofoam insulation inside the compartment separator.

Servicing the Evaporator Fan Motor

1. Disconnect the two (2) wire connectors from the evaporator fan motor.

2. Remove the two (2) screws securing the evaporator fan motor bracket to the fan scroll.

3. The fan blade is pressed onto the motor shaft. The motor shaft should not extend past the fan

blade hub.

Servicing Components in the Freezer Compartment

DEFROST

HEATER

(Under Evaporator)

EVAPORATOR

FAN MOTOR

HEAT

LOOP

EVAPORATOR

HEAT

SHIELD

CENTER

RAIL

BRACKET

Fig. 12

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

No comments

Roper TOP-MOUNT REFRIGERATOR Specifications Page 14