Roper TOP-MOUNT REFRIGERATOR Specifications Page 64

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 63
58
MID-LINE DESIGN 16 thru 22 cu. ft. Top-Mount
UNCLIP TO
REMOVE
THERMOSTAT
PULL BRACKET
OUT OF SLOT
RED
WIRE
ORANGE
WIRE
AIR
DAMPER
SENSOR TUBE FITS INTO SLOT HERE
UNCLIP
BRACKET
GREEN
WIRE
FORM LOOP
HERE
THERMAL
WEIGHT
ACCESS
SLOT
SLOT
ADHESIVE
FOAM COVER
THERMAL
WEIGHT
INSET
Servicing the Freezer Section
Fig. 71
Removing the Freezer Light Assembly
Early Production Models
Some early Production Models of Mid-Line Refrigerators were equipped with a magnetically oper-
ated electronic light switching system. If the unit being serviced does NOT have a rocker switch on
the freezer light assembly, follow these instructions.
Door Magnet - The door magnet may be attached to the door with only an adhesive or it may have
a mounting screw. Replacement door magnets are supplied with a pre-drilled hole and a self-
tapping screw .
1. If the door magnet does not have a mount-
ing screws, pull the magnet away from the
door until the adhesive tape is free of the
door liner.
(Fig. 72)
2. If the door magnet has a mounting screw,
remove it and then pull the door magnet from
the door liner as instructed above.
DOOR MAGNET
MOUNTING
SCREW
DOOR LINER
Fig. 72
Page view 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 107 108

Comments to this Manuals

No comments