Roper TOP-MOUNT REFRIGERATOR Specifications download pdf (Page 50)

NEW DESIGN 14 cu. ft. Top-Mount

DEFROST

HEATER

PLUG

DEFROST

HEATER

ELEMENT

EVAPORATOR

HEATER

BRACKET

CUT HERE

& BEND

DOWN

DEFROST

HEATER

SLIDE

DEFROST

HEATER

OUT

Fig. 55

INSET

Adjusting the Air Tower

The air tower has three temperature slots that allow an increase or decrease in the cold air flow to

vary the temperature inside the freezer. If the freezer is too warm or too cold, adjusting the slots in

the tower will help correct the problem.

To change the air tower settings, the air tower must be removed from the evaporator cover at the

back of the freezer section. (See Figure 56, page 45.)

1. Open the freezer door and remove all the contents.

2. Remove the two (2) Phillips-head screws (or plastic “canoe” clips) securing the front of the

freezer’s inner floor.

3. Remove the two (2) Phillips-head screws securing the rear of the freezer inner floor. Re-

move the inner floor.

4. Press against the top of the air tower to disengage the two (2) clips from the evaporator

cover. Then, lift the tower and pull it forward to release the four (4) hooks from the evapora-

tor cover. Remove the air tower from the freezer.

DEFROST

HEATER

DISCONNECT

HARNESS

PLUG

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 107 108

No comments

Roper TOP-MOUNT REFRIGERATOR Specifications Page 50