Roper TOP-MOUNT REFRIGERATOR Specifications download pdf (Page 19)

OLD DESIGN 12 & 14 cu. ft. Top-Mount

Section Two

Old Design

12 & 14 cu. ft. Top-Mount

It is critical that the refrigerator/freezer be properly leveled. Both the back and front of the unit should

be carefully leveled before it is turned on.

1. Place a board across the rear of the installed position and set a level on the board.

(Fig. 15)

2. Place shims where the rear rollers will sit to level the board.

3. Remove the board and leave the shims in place.

4. Place the unit in its installed position.

Leveling the Refrigerator/Freezer

INSTALLATION CONSIDERATIONS

Measure the opening at the location in which the refrigerator/freezer is to be installed and make

sure the following minimum clearance dimensions are followed.

Top: At least 3” (7.5cm) clearance between

the overhead cabinet and the refrigerator/

freezer top. (Dimension A)

(Fig. 14)

Sides: At least 1” (2.5cm) clearance on each side

of the refrigerator/freezer. (Dimension B)

(Fig. 14)

Back: At least ½” (1.25cm) clearance between

the condenser (“Old Design” 14 cu. ft.

Top-Mount) and the wall.

Fig. 14

Fig. 15

Board

Level

Minimum Clearance

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 107 108

No comments

Roper TOP-MOUNT REFRIGERATOR Specifications Page 19