Roper TOP-MOUNT REFRIGERATOR Specifications download pdf (Page 46)

NEW DESIGN 14 cu. ft. Top-Mount

Removing the Control Box

The Control box is attached to the bottom of the divider wall separating the freezer and refrigerator

compartments. The control box contains the defrost timer and the operating thermostat.

1. Open the refrigerator door and slide the top shelf out.

2. Remove the hex-head screw for the front of the control box.

(Fig. 47)

3. Lower the front of the control box slightly and pull it forward to release the slots in back from

the two tabs in the top of the refrigerator compartment liner.

4. Carefully lift the thermostat sensor tube from the hooks in the warm air return.

5. Slide a screwdriver blade under the front skirt of the top connector to unlock the tab and

disconnect the control box plug from the wiring harness connector.

Servicing the Defrost Timer

The defrost timer is held inside the control box by three clips. The thermostat sensor tube rests in a

slot at the back of the control box and must be removed from the slot and positioned out of the way

when the defrost timer is removed.

1. Unclip the sensor tube from the groove

at the back of the control box and position

it out of the way.

2. Press out on the two indicated clips

(Fig. 49)

and remove the defrost timer.

3. Disconnect the wiring harness plug from the

defrost timer terminals.

LIGHT

SOCKET

LIGHT

SWITCH

SENSOR

TUBE

CONTROL

BOX

DEFROST

TIMER

THERMOSTAT

KNOB

PLUG

CONNECTOR

PRESS

OUT THIS

CLIP

PRESS

OUT THIS

CLIP

UNSNAP SENSOR TUBE FROM SLOT

AND MOVE OUT OF THE WAY

SENSOR TUBE

CLIP

PINS

WIRING HARNESS

CONNECTOR

CONTROL BOX PLUG

HEX-HEAD

SCREW

CONTROL BOX

Fig. 49

Fig. 48

Fig. 47

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 107 108

Comments to this Manuals

No comments

Roper TOP-MOUNT REFRIGERATOR Specifications Page 46

Comments to this Manuals

Related products and manuals for Fridges Roper TOP-MOUNT REFRIGERATOR