Roper TOP-MOUNT REFRIGERATOR Specifications download pdf (Page 47)

NEW DESIGN 14 cu. ft. Top-Mount

Servicing the Thermostat

1. Pull the knob off the thermostat control.

2. Unclip the sensor tube from the groove at the back of the control box.

3. Lift the thermostat out of the tabs securing it to the control box.

4. Disconnect the three wire connectors from the terminals of the thermostat.

NOTE: The inside of the thermostat control knob has a wide and a narrow slot

(Fig. 50, Inset).

Match these slots with the tabs next to the thermostat shaft and

press the knob over the tabs.

ORANGE

WIRE

RED

WIRE

GREEN

WIRE

TAB

TABS

THERMOSTAT

UNSNAP SENSOR TUBE

FROM BACK OF UNIT

KNOB

WIDE

SLOT

NARROW

SLOT

Servicing the Freezer Section

The Bi-Metal, Evaporator Fan and Defrost Heater can all be accessed in the Freezer Section after

the Evaporator Cover has been removed.

Removing the Evaporator Cover

1. Open the freezer door and remove the ice cube trays and shelf.

2. Remove the two (2) Phillips screws (or plastic “canoe” clips) from the front of the freezer’s

inner floor.

(Fig. 51)

3. Remove the automatic ice maker, if present.

4. Remove the two (2) Phillips screws from the rear of the freezer’s inner floor and remove the

floor.

(Fig. 51)

Fig. 50

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 107 108

No comments

Roper TOP-MOUNT REFRIGERATOR Specifications Page 47