Roper TOP-MOUNT REFRIGERATOR Specifications Page 77

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 76
71
Section Five
TROUBLESHOOTING AND DIAGNOSIS
HEAVY WARM LOAD
The amount of warm food placed in the refrigera-
tor affects running time and power consumption.
Ordinarily, when a supply of food is placed in a
refrigerator, it will operate continuously until the
food is down to the desired storage temperature.
This continuous operation is normal. In high am-
bient room temperatures, an excessive warm load
may cause overload cycles.
EXCESSIVE DOOR OPENING
The length of time the door is left open and the
number of times the door is opened should be
held to a minimum. Excessive door opening will
greatly increase running time, power consump-
tion and frost buildup.
IMPROPER PACKAGING
Uncovered foods and improper packaging mate-
rials and methods cause food to dry out. This
reduces the flavor of foods and results in an ex-
cessive frost buildup. Refer the customer to the
Owner’s guide that came with the refrigerator.
GENERAL
WARM ROOM
1. A warm room or other large source of heat
(such as a range, heater, hot air duct, sunny
window) can affect the performance of the re-
frigerator. If the room ambient temperature
exceeds 100°F, running time will approach
100%.
2. At temperatures approaching 120°F, the re-
frigerator may cycle on the overload.
3. In general, the warmer the room, the greater
the running time and power consumption.
EXTERIOR SWEATING
Refrigerators are designed to prevent “runoff”
moisture at ambient room temperatures of 90°F
and relative humidity of 90%. There may be a
thin film of moisture on some areas at a lower
temperature and relative humidity. This is within
design specifications and is not a fault of con-
struction.
Relocating the refrigerator in a less humid and
better ventilated area will normally eliminate most
moisture problems.
ELECTRIC SHOCK HAZARD
Disconnect the electrical power before performing any diagnostic test,
continuity test or attempting any servicing of any components.
Failure to do so can result in death or electrical shock.
! WARNING
Page view 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 107 108

Comments to this Manuals

No comments